Local roofersFree to callNo forms to fill out
Serving Morristown and nearby towns
Menu
Call (862) 363-5004
Metal Roofing

Metal Roof Installation Morristown, NJ

A Morristown roofer can help you choose between standing seam, ribbed panels and metal shingles and install the full system, with high-temperature underlayment, matched trim and closures at every edge. One call to (862) 363-5004 reaches a nearby roofer who installs metal roofs.

Before anything else, a metal roof starts with picking how the panels attach. Ribbed and corrugated panels fasten through the face with washered screws, which keeps installation simple but leaves fasteners exposed to the weather. With standing seam, hidden clips hold the panels and let them move, which is why it is the premium residential choice.

Next comes the metal itself and the paint on it. Galvanized and Galvalume coated steel cover most homes, aluminum resists corrosion near salt air, and copper and zinc are long-lived specialty metals. PVDF finishes resist fading better than SMP finishes, and gauge, where a lower number means thicker metal, affects dent resistance.

Underneath, a metal roof needs the right support. A solid deck covered with high-temperature underlayment is the usual base, plus ice and water shield at eaves and valleys where needed. Some barns and shops use purlins instead, but a house roof is quieter and drier over a deck.

Metal Roof Installation is often paired with standing seam metal roof and metal roof replacement, depending on the cause.

Dealing with this in Morristown, NJ right now? Call (862) 363-5004 to talk to a local roofer.

Call now
The process

The steps of a metal roof installation

Here is the usual order for a new metal roof.

  1. Select materials

    The roofer helps you pick the panel type, metal, gauge, finish and color, then measures every slope precisely. Accurate measurements mean fewer end laps.

  2. Get the base ready

    Rotted decking is replaced and the surface made flat before any metal goes on. Bad decking telegraphs right through thin metal.

  3. Dry in the roof

    A heat-rated underlayment goes down over the whole roof, plus an ice barrier in leak-prone areas. This layer is the backup if water ever gets past the metal.

  4. Edge flashing

    Eave trim and drip edge go on first, along with valley flashing, so panels can lap over them. The order of trim matters because every piece has to lap water downhill.

  5. Run the panels

    Panels are set square to the eave and fastened with clips or washered screws in the spots the panel maker specifies. Screws are driven snug, never crushed, so the washer seals.

  6. Flash the penetrations

    The ridge, walls, chimneys and pipes are flashed, and closures seal the gaps under the trim. On roofs that hold snow, snow guards keep it from sliding off in a sheet.

What is included

A complete metal roof

Closures

Vented ridge closures let the attic breathe and block insects and birds.

Snow guards

Every pipe gets a metal roof boot, and snow guards go above doors so nothing is left to improvised sealant.

Custom flashing

Eave, rake, ridge, valley and wall trim in the same finish to avoid corrosion between metals.

Panel selection

Standing seam, ribbed panels, metal shingles or stone coated steel with a finish chosen for long color life.

High-heat underlayment

An underlayment that tolerates high roof temperatures so it does not stick or break down.

Related service

Metal Roofing Contractor Morristown, NJ

Metal roofing is its own trade, with seaming tools, brakes for bending trim and an understanding of thermal movement. It is fair to ask about the panels they prefer, the gauge they recommend and how they flash chimneys and walls.

A metal roofing contractor in Morristown should talk you through panel, gauge, finish and snow guards without pushing one answer. Looking at finished roofs is the best way to judge straight panels and clean trim.

Related service

Stone Coated Steel Roof Morristown, NJ

A stone coated steel roof uses steel panels coated with stone granules set in an acrylic base, shaped to look like shake, tile or shingles. The textured finish hides minor dents and quiets rain, and the panels are much lighter than clay or concrete tile.

Stone coated steel is usually installed over battens, which create an air space under the panels. On a Morristown house that wants the look of tile or shake, stone coated steel avoids the extra structural load.

Related service

Metal Shingle Roof Morristown, NJ

A metal shingle roof uses smaller interlocking pieces stamped to look like shingles, slate or shake. Hidden fasteners and small units make them a good fit for roofs with dormers and valleys.

In Morristown, metal shingles appeal to homeowners who want metal performance with a traditional look. The roofer follows the specific instructions for that shingle profile.

Local help

Metal Roof Installation Near Me

Metal roofs are going on more Morristown homes every year, alongside the shops and barns that have used metal for generations. Older buildings in Morristown and nearby towns like Cedar Knolls, Morris Plains, Whippany and Madison often have exposed fastener panels, while newer homes lean toward standing seam or metal shingles, so it pays to compare systems before choosing.

For metal roof installation in Morristown, NJ or nearby towns like Cedar Knolls, Morris Plains, Whippany and Madison, call (862) 363-5004 to reach a roofer who covers your street.

Roofs in this climate

Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. That is why roof repair in Morristown is busiest after a hard winter and before the next one.

Why call

Why not wait

Less damage

A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.

Familiar with local homes

Roofers in Morristown know the roof types and weather wear common in local homes.

Know what happens next

Ask your questions before you agree to anything.

Metal Roof Installation FAQ

How noisy is a metal roof?
The noise depends on what is under the panels. Panels fastened to purlins with nothing under them make the most noise. Stone coated steel and metal shingles are among the quietest options.
Does a metal roof attract lightning?
A metal roof does not make a strike more likely. Height and isolation decide where lightning hits. Metal is also noncombustible, which helps if a strike does occur.
How long does a metal roof last?
Metal roofs often last two or three times as long as asphalt shingles. Coated steel, aluminum and copper all last a long time, with copper and zinc the longest. Proper trim, flashing and maintenance help the roof reach its full life.
What gauge of metal roofing should I use?
Gauge describes thickness, and a lower number means thicker metal. Most homes use 24 or 26 gauge steel, while 29 gauge is common on outbuildings. The right gauge depends on the panel and the weather it faces.
Should I choose standing seam or exposed fastener metal roofing?
The two systems attach the metal in different ways. Exposed fastener panels are screwed through the face, which is simpler and quicker but leaves washers that will need replacing, while standing seam uses hidden clips that let the panels move. Many homeowners choose standing seam for houses and exposed fastener for barns and shops.

More questions? Call (862) 363-5004

Often needed together

  • Standing Seam Metal Roof

    Standing seam metal roofs with concealed clips, raised seams and no exposed screws in the panels, with matching trim, closures and snow guards.

    Learn more
  • Metal Roof Replacement

    Tearing off failed metal panels, repairing the framing and putting on a new metal roof, with purlins and decking checked before new panels go on.

    Learn more
  • Roof Installation

    Putting on a new roof the way the material maker intends, whether it is asphalt shingles, metal or another material.

    Learn more
  • Commercial Metal Roofing

    Installing, replacing and repairing metal roofs on warehouses, shops, offices and other commercial buildings, built to handle thermal movement and wind uplift.

    Learn more

Looking for something else?

See all roofing services

Get metal roof installation help in Morristown

Call (862) 363-5004 to talk to a roofer serving Morristown, NJ.

Talk to a local roofer(862) 363-5004Call now

Free to call. No forms to fill out.

Call (862) 363-5004